Customize Traffic Filters

Complete the Add a Network Policy task.

Select traffic filters to control which management and diagnostic services an AP may receive, and whether to allow traffic between clients connected to the AP.

This task is part of a series for configuring the Optional Settings for a standard wireless network. Use this task to customize optional traffic filter settings.

Go to Configure > Network Policies.
Select an existing policy, and then select .
Select Next to open the Wireless Network page.
Go to Additional Settings > Optional Settings, and then select CUSTOMIZE.
Go to the Traffic Filters section.
Select or clear the following check boxes to permit or deny specific types of management and diagnostic access to the mgt0 interface, or to enable traffic between clients connected to the AP.
- Enable SSH
- Enable Telnet
- Enable Ping
- Enable SNMP
- Enable Inter-station Traffic
Note
When an Ethernet interface is in access mode, stations can communicate directly with each other without sending traffic through the AP. In this case, the AP cannot control their traffic. However, the AP can block traffic between stations connected to an Ethernet interface and stations connected to a wireless interface through an SSID.

Continue configuring Optional Settings in the Wireless Networks configuration window. Select SAVE OPTIONAL SETTINGS to save your changes.